OPEN-CLIP ---> This kit build in the ATmega8 chip, and use OPENWII 5 Pins method, you can download the free chip core like Chiip / OpenWii / WiiSKAS / Wiikey to make your own PLUG and PLAY upgradeable Wii chip in few minutes!

And it support D2A/D2B and DMS console only, not support the D2C console, and don't support the pins-cut version too.

The OPEN-CLIP build in the MEGA8L chip! can re-program through the KEY-Programmer!


The OPEN-CLIP circuit :


Download : OpenWii 2.4 Release! --- By andii

http://www.openwii.org/forums/viewtopic.php?t=683

Finally its done!

OpenWii 2.4 for Atmega8 (Chiip) & Attiny (Wiip)

New Features:

- Audiofix

- DualLayer Support

- New LED blink codes (L = long blink, S = short blink)

Power Up: L S
Drive Patched: L S S (e.g. each disc change)
Set Region / Speed / Audifix: L S S S (using setup disc)
Upgrade Firmware: LED flashes (update is finished when led is off)


- New setup disc behaviour

The chip update is now starting automatically if no GameCube controller is connected.
If you want to change your configuration, ensure to connect a GameCube controller in port 1 before starting the setup disc!
Tip from HisshouBuraiKen: If you're using wavebirds GC controller make sure to hold down a button when the disc boots up (b, x or y should work fine) - otherwise recognizing the controller will fail.

- Attiny support

Due to the limited flash size the Attiny firmware does not support the LED blinking and the audiofix can not be switched off via setup disc. Update via setup disc is not supported.


Special thanks to Bell from YAOSM for helping me to make this release possible!


Enjoy!

EDIT (15.Mar.2008): Added Attiny hex files, updated source code
EDIT (28.Feb.2008): Minor bugfix - Updated downloads to fixed version